Hydrogen Measurement & Extraction at Nevada Solar One
DOI:
https://doi.org/10.52825/solarpaces.v2i.967Keywords:
Hydrogen, Measurement, ExtractionAbstract
Hydrogen was measured and extracted from the headspace gas of four expansion vessels that are components of the heat transfer fluid (HTF) subsystem in the Nevada Solar One (NSO) power plant, Boulder City, Nevada. Direct, real-time measurements of hydrogen partial pressures in the headspace gas were accomplished using the recently installed hydrogen mitigation process that was developed jointly by the National Renewable Energy Laboratory (NREL) and Acciona Energy, the owner/operator of NSO. This method combines the two functions of extracting hydrogen from the headspace gas and measuring hydrogen partial pressure in the headspace gas. During 2022 and 2023, we operated the process regularly and made real-time measurements of hydrogen partial pressures. In addition, DLR in Germany measured dissolved hydrogen concentration in the circulating HTF. These two measurements were compared via Henry’s Law and found to be consistent. Measured values also were compared to model results that were generated by the NSO plant model that was written to predict hydrogen levels in the power plant piping and components. The model predicted hourly hydrogen partial pressures in the expansion tanks for two cases - hydrogen extraction off, and hydrogen extraction on. Real-time hydrogen measurements and sampled HTF measurements were compared to hydrogen levels that were predicted for these two cases. We found good agreement between the hydrogen measurements and the modeled hydrogen for the extraction on case. These results indicate that the extraction process is working properly with its expected performance.
Downloads
References
[1] G. C. Glatzmaier, “Development of hydrogen mitigation for Nevada Solar One power plant,” NREL/TP-5500-75127, 2020, https://www.nrel.gov/docs/fy20osti/75127.pdf
[2] G. C. Glatzmaier, R. Cable, and M. Newmarker, “Long-term heating to improve receiver performance,” AIP Conf. Proc. 1850, 020006, 2017, doi: https://doi.org/10.1063/1.4984330
[3] G. C. Glatzmaier, R. Cable, and M. Newmarker, “Steady-state plant model to predict hydrogen levels in power plant components,” AIP Conf. Proc. 1850, 020008, 2017, doi: https://doi.org/10.1063/1.4984332
[4] G. C. Glatzmaier and D. A. Cooney, “Sensor for measuring hydrogen partial pressure in parabolic trough power plant expansion tanks,” AIP Conf. Proc. 1850, 020007, 2017, doi: https://doi.org/10.1063/1.4984331
[5] G. C. Glatzmaier, “Hydrogen sensor for parabolic trough expansion tanks,” AIP Conf. Proc. 2033, 030006, 2018, doi: https://doi.org/10.1063/1.5067022
[6] K. F. Beckers and G. C. Glatzmaier, “Addressing solar power plant heat transfer fluid degradation: Experimental measurements of hydrogen transport properties in binary eutectic biphenyl/diphenyl ether,” Solar Energy 173, 304–312, 2018
[7] K. F. Beckers and G. C. Glatzmaier, “Modeling and simulating diffused aeration for hydrogen removal from expansion tanks of parabolic trough solar thermal power plants,” AIP Conf. Proc. 2033, 030001, 2018, doi: https://doi.org/10.1063/1.5067017
[8] G. C. Glatzmaier, “Integrated hydrogen sensor and separator for parabolic trough expansion tanks,” AIP Conf. Proc. 2126, 120007, 2019, doi: https://doi.org/10.1063/1.5117625
[9] G. C. Glatzmaier, “Hydrogen sensing and separation,” U.S. Pat. No. 10,646,821, 2020
[10] G. C. Glatzmaier and K. F. Beckers, “Hydrogen mitigation process installation at Nevada Solar One,” AIP Conf. Proc. 2303, 110002, 2020, doi: https://doi.org/10.1063/5.0031968
[11] G. C. Glatzmaier and K. F. Beckers, “Hydrogen mitigation process testing at Nevada Solar One,” AIP Conf. Proc. 2445, 100001, 2022, doi: https://doi.org/10.1063/5.0086416
Downloads
Published
How to Cite
Conference Proceedings Volume
Section
License
Copyright (c) 2024 Greg C. Glatzmaier
This work is licensed under a Creative Commons Attribution 4.0 International License.
Accepted 2024-06-20
Published 2024-10-15
